Samsung Monte Flashing Guide

Samsung Monte Flashing

---

Samsung Monte is very easy to Flash if you do it once but when you are doing this for the first time you should be careful .

First you should complete the downloading job.

Download All the listed Files if you don't have them.

Samsung Kies : Download
Multiloader : Download
Samsung Firmware
S5620XEJE1 : Direct Download
                                          S5620MFJF1 : Direct Download


Now let's Get Started

Follow all the steps carefully,

• After all files are downloaded , extract the firmware files.
• Install Kies on your PC.
• Run Multiloader and select BRCM2153 under controls and then select Boot Change .

• Browse for the Folder Named Boot Files in your PC . These files are on the same folder where you extracted your Firmware Files.
• Then, select Full Download and browse for other Files respectively as shown in the figure below
• ***FOTA, TUNE and ETC fields are left blank.****
• Now, Switch off your phone and remove sim card and memory card.
• Set your phone to DOWNLOAD mode . (Hold: the volume down button and red(cancel) button together when the phone is switched off)
• Now, Connect your phone to the PC through USB cable and Click on Port Search button and when it finds your phone and shows your phone name then click on download button.
• Finally , you just have to wait till the flashing is finished and your phone automatically restarts.

    If you want a video tutorial Check This (Recommended for First Time Flashers)